Sean Hyland Motorsport report

[SJ Cobra]

:allhail: Just want to let my fellow Stangers know of my experiance with SHM. They came and picked my car up and I had a 575 Longblock installed along with some other necessary goodies. From my initial phone call to Scott (SHM's sales rep) to the final delivery of my car back to me, these guys are CLASS!!;)
My project came back to me dynoed at 560rwhp, and a very safe air/fuel trim. Initial dyno showed 592rwhp, but A/F was a bit lean @WOT, so Sean dialed her back a bit. Got the car Wed. nite, drove it last nite. WOW!!!!!!!!!!!!! Now before it went to SHM, I was pushing 482rwhp, so it was no sloutch. Very clean job!! Anyone looking for 4.6 mods, I would highly recommend SHM, at least give Scott a call (519)421-2291. Thanks Sean and Scott and look forward to seeing you in Ohio next summer!:beer:
---------------------------
01' Cobra vert. #552 of 3384 build
mods too long too list

PS/ This still runs on the returnless fuel system!!

[keelhauld]

This site is pretty good, I like the lay out.

Do they do superchargers without top end work?

Has anybody here done that?

[NeilBerry]

:geek:

The 1999 & 2001 Cobras have been observed to go into an anti-flee mode during OpenRoadRacing when travelling over 130mph for extended periods. Observed every 10 miles in some cars, but less often when the speeds are lower.

Has this ever occured in a Sean Hyland Motorsports(SHM) prepared car? Is there a cure this race observed behavior?

[GaborVincer]

I havenever herd of a anti-flee mode I have run my car hard but not full out for any long period of time, to meny cops:haha: :haha:

[Venomizd]

Glad to hear they took good care of you. They did a Novi 2000 a few years back and a ton of other work on my car and its worked out great. I have been on the phone with them in the last few weeks talking about building up my shortblock and turning up the boost so I may be going back for my yearly check up soon.:spinem:

[SVTgirl]

never had any work done there... the only thing I did was order a set of blower cams from SHM.

[arboc96]

Originally posted by SVTgirl
never had any work done there... the only thing I did was order a set of blower cams from SHM.

for the new motor van? :tmb:

[khaine]

Originally posted by arboc96
for the new motor van? :tmb:

we all know it's for the new motor :D

[U TINK]

Originally posted by SVTgirl
never had any work done there... the only thing I did was order a set of blower cams from SHM. Geez Van sounds like you and I are building the same motor.I`m using ModMax shafts.What compression you running and boost?:)

[khaine]

Originally posted by U TINK
Geez Van sounds like you and I are building the same motor.I`m using ModMax shafts.What compression you running and boost?:)

lol, and here I am about to swap in a cobra motor :D

[U TINK]

Originally posted by khaine
lol, and here I am about to swap in a cobra motor :D LMAO Chris!:tmb:

[khaine]

Originally posted by U TINK
LMAO Chris!:tmb:

yeah yeah... laugh now while you still can :D

[U TINK]

Originally posted by khaine
yeah yeah... laugh now while you still can :D Oh I certainly will!:bna